How to install the solar container lithium battery cabinet

How to protect a lithium battery energy storage cabinet?

At the same time, setting the charging and discharging parameters, configuring the safety and protection settings, and protecting the lithium battery energy storage cabinet from potential dangers such as overcurrent, overvoltage, and overtemperature are necessary.

How do I connect a battery cabinet to an ups?

In systems with more battery cabinets, only the system BMS of battery cabinet 1 (the battery cabinet closest to the UPS) is connected to the UPS. Remove signal cable 0W13441 between the SMPS I/O port and the DRY CONTACT ports on battery cabinet 2 and battery cabinet 3. • SG IO 1: Used for sending signals for minor and major alarms to the UPS.

How do I reinstall a battery cabinet?

Perform the following steps on all battery cabinets in the battery solution. a. Remove the cover in front of the start-up button and push the start-up button. • The PSU2 LED and the POWER LED will turn on. • The ABNORMAL and ALARM LEDs should remain off. b. Reinstall the cover in front of the start-up button.

How do you protect a battery cabinet?

High-quality cables, connectors, and terminals establish safe electrical connections between battery cabinets and other system components. And add appropriate fuses and circuit protection devices to the circuit to prevent overcurrent, overvoltage, and short circuits.

How many battery cabinets can one AC/DC converter box supply?

1. One AC/DC converter box can supply up to 10 battery cabinets. For 11+ battery cabinets, at least two AC/DC converter boxes are required. 2. Install one data log kit for each battery system. Installation Procedure 1. Prepare for Installation, page 19. 2. Install the Rear Seismic Anchoring, page 21. 3.

How do you level a battery cabinet?

Lower the levelling feet until they connect with the floor - use a bubble-leveler to ensure that the cabinet is level. 4. Push the second right-most battery cabinet into position, align with the seismic anchoring (if any), and level the battery cabinet as described in step 2 and step 3. 5.